Dynamic Instrumentation is a feature of supporting Datadog tracing libraries. If you are already using APM to collect traces for your application, ensure your Agent and tracing library are on the required version, and go directly to enabling Dynamic Instrumentation in step 4.

Prerequisites

For a better experience, Datadog recommends enabling autocomplete and search (in Preview).

Installation

1. Install or upgrade your Agent to version 7.45.0 or higher.

2. If you don’t already have APM enabled, in your Agent configuration, set the DD_APM_ENABLED environment variable to true and listening to the port 8126/TCP.

3. Install or upgrade the .NET tracing libraries to version 2.54.0, by following the relevant instructions for .NET Framework or .NET Core.

   Note: Dynamic Instrumentation is available in the dd-trace-dotnet library in versions 2.54.0 and later.

4. Run your service with Dynamic Instrumentation enabled by setting the DD_DYNAMIC_INSTRUMENTATION_ENABLED environment variable to true. Specify DD_SERVICE, DD_ENV, and DD_VERSION Unified Service Tags so you can filter and group your probes and target active clients across these dimensions.

5. After starting your service with Dynamic Instrumentation enabled, you can start using Dynamic Instrumentation on the APM > Dynamic Instrumentation page.

Configuration

Configure Dynamic Instrumentation using the following environment variables:

What to do next

See Dynamic Instrumentation for information about setting snapshot and metric probes and browsing and indexing the data.

Further Reading

추가 유용한 문서, 링크 및 기사:

Getting Started with Datadog AgentDOCUMENTATION